electronics progress 2017-03-01


Part of the Electrical panel "covered" with a black paper to make the magnetic grapple look
good when the door is closed and the panel open. See picture on right.

I left Picaxe and started to use Arduino in 2015. I still learning, but together with Pololu servo
controller it makes an easy and clean setup.

On the back of the utility arm carrier I have the Pololu for all body panels/doors and arms.
The green wire is the Signal from the Arduinos. In this picture you can also see the servos for the "gadgests" in each large front door compartment. See "Body" page for some more pictures.